Neck Traction Stretcher Belt Cervical Head Brace Physical Pain Relief Device

Must choose a 1.2" - 1.7" thick solid core door, or steel door. Use on hollow core doors. Otherwise, there will be a risk of falling and being injured. Ratchet traction frame, automatically stuck, easy to operate.

Thickened traction belt, perfectly saturated mandible, good texture. The dynamometer can effectively monitor the tension coefficient, which is helpful for neck recovery. Velcro design can be adjusted to suit your own size, simple and convenient. Removable design for easy carrying and storage. Suitable for people who is smartphone addicts, fatigued driving, poor sleep, office workers.

Enhancing the flexibility of the neck muscles and the range of motion of the neck. Relaxing the neck muscles, relieve neck pain, and use neck pullers to energize the entire body. Traction Bracket: with blue rubber pad, which will not scratch the door panel. The width of the opening can be adjusted from 1.2 inches to 1.7 inches, put the opening of the traction bracket on the door frame. Gear Design: pull the rope and adjust the height through a ratchet to prevent reverse rotation, saving labor and safety.

Pull the drive traction belt and the upper traction rope with the head upward to a comfortable position to stop pulling. Dynameter: the maximum traction force is 98n, and the error of the dynamometer is ±15% or ±10n (whichever is greater), it allows you to cope with adjustment.

Traction Belt: front traction belt with velcro long edge, made of canvas fabric, skin-friendly and durable, comfortable and not easily damaged. Neck puller time: generally about 15-30 minutes or as prescribed by the doctor. Installation of traction bracket:adjust the long side of the bracket up and down so that the blue pad on three sides are tightly fitted to the door panel. Shake the bracket up and down to check if it is firmly installed. Loosen the ratchet rope: pull the rope below the bracket and pull the grey rope below the ratchet at the same time to loosen all the ropes of the ratchet.

Installation of traction straps: the traction Belt is divided into two pieces and placed on the lower jaw (long side of velcro) and the back of the neck. Adjustment of traction height: the patient with cervical spondylosis sits in a chair and gradually pulls the traction belt above the ratchet until the traction belt is cling to the sides of the face. Traction in progress: adjust to a comfortable position, you can put your hands down, without always pulling the traction rope. Aged, weak, and in poor general condition : This type of patient is prone to accidents during traction and should be used with caution. Especially in patients with severe cervical degenerative changes and bone bridge formation.

For patients with cervical spondylotic myelopathy who are over 50 years old and have a long course of disease, traction therapy may aggravate the condition, so it should not be used. In order to prevent accidents, such cases should be routinely photographed on the anterior and lateral cervical radiographs before traction to exclude patients with bone destruction and osteoporosis such as tuberculosis and tumors. Cervical vertebra fracture and dislocation.

Rigid vertebral traction is prone to cause cervical spine fracture and dislocation or exacerbate paralysis caused by cervical spine fracture and dislocation, and is prohibited. Proposed surgery: Such cases are often accompanied by significant pressors, which may not only cause accidents during traction, but also cause relaxation of the cervical paravertebral muscles and ligaments after heavy traction, leading to slippage of the internal fixation or implanted bone mass after surgery. Those who have symptoms that can worsen after traction, such as falling pillows, neck sprains, cardiovascular diseases, severe spinal stenosis, and mental disorders, should be cautious in using to prevent worsening of the condition or accidents. 1x Canvas Traction Belt with Hook.